The Add on 4 Way Cross allows additional work to be carried out without dismantling existing structure.

A 4 way cross that enables the vertical to pass through the centre of the fitting with the four horizontal tubes joining at 90° to each other. Ideal for structures with multiple verticals. The vertical must remain either continuous with the cross rails being cut.

An inline internal tube connector for joining two tubes of the same diameter. This fitting can only be used with 3.2mm wall thick tube. This fitting is not recommended for high or tensile load applications.

An inline external tube connector for joining two tubes of the same diameter. This fitting is not recommended to be used in high load applications. For a smooth inline joint the Q clamp fitting 150 can be used.

NOTE: When using Q clamp 148 fittings for the top rail of a guardrail,the top of the upright must NOT be reduced in length but left at full height. The top of the tube will need to be capped using a Q clamp 133.

Shown priced and sold as a single fitting but normally used in pairs to create angles between 85° and 235°. A central tube is required to join the fittings together to create the angle. When working out the correct tube length dimension ‘C’ should be subtracted.

An internal swivel tee used in conjunction with other Q clamp fittings in the range to create a 360° swivel joint. Ideal use on handrail or offset guardrailing down variable angled slopes. Eliminates the requirement for specialised angle fittings.

WARNING: DUE TO THE NATURE OF THESE GALVANISED CASTINGS THE MEASUREMENTS GIVEN HERE CANNOT BE PRECISE. WE THEREFORE DO NOT RECOMMEND THAT ANY BOLT HOLES ARE PRE-DRILLED PRIOR TO INSTALLATION.

Structural flush side palm base fixing guardrailing to wall, steps or ramps etc. The flush design enables posts to be tight to the structure. The tube is unable to pass through the fitting. Should this be required then the base must be reamed out. If the base is reamed out the bottom fixing will become redundant.

WARNING: DUE TO THE NATURE OF THESE GALVANISED CASTINGS THE MEASUREMENTS GIVEN HERE CANNOT BE PRECISE. WE THEREFORE DO NOT RECOMMEND THAT ANY BOLT HOLES ARE PRE-DRILLED PRIOR TO INSTALLATION.

This fitting is designed for palm fixing guardrailing and balustrading to walls, parapets, steps and ramps.

WARNING: DUE TO THE NATURE OF THESE GALVANISED CASTINGS THE MEASUREMENTS GIVEN HERE CANNOT BE PRECISE. WE THEREFORE DO NOT RECOMMEND THAT ANY BOLT HOLES ARE PRE-DRILLED PRIOR TO INSTALLATION.

Structural offset side palm base fixing guardrailing to walls, steps, ramps, etc. The tube is unable to pass through this fitting as supplied. Should this be required then the base must be reamed out. Access to the top fixing is restricted. It is recommended that a threaded stud is fixed first with a maximum projection of 25mm.

THIS FITTING IS NOT RECOMMENDED FOR USE AS A BASE PLATE FOR GUARDRAILING

WARNING: DUE TO THE NATURE OF THESE GALVANISED CASTINGS THE MEASUREMENTS GIVEN HERE CANNOT BE PRECISE. WE THEREFORE DO NOT RECOMMEND THAT ANY BOLT HOLES ARE PRE-DRILLED PRIOR TO INSTALLATION.

With four countersunk holes, this fitting is ideal as a flange to terminate handrail to a wall or other similar application. This fitting may be used on structures where it is only required as a positional fixing.