A galvanised stop end for use in the end of tubes. This stop end is suitable for medium gauge tube only. This is only a friction fit and for a more permanent fix an adhesive is recommended.

Chain hook. Used to locate chains across openings. Not ideal for permanent chain location. Recommended that one end of the chain is fixed using a Q clamp fitting reference 173M and held in place with a nut and bolt.

A locking collar used as extra support for a Q clamp fitting on structures where the slip load on the grubscrew may be exceeded i.e. racking. Can also be used to support a Q clamp fitting that is required to be left undone, i.e. a gate hinge.

Add on Side Outlet Tee designed to allow additional work to be added without taking existing structure down.

Three way tee used to join 3 tubes at 90° to each other with the vertical passing through the fitting. Typical use would be on structures such as market stall or play frames.

Double location weldmesh panel clip. The slotted design of the panel clip enables adjustment in the location of the mesh panels. Supplied with M6 x 30mm long nut and bolt. This fitting can also be used to locate other materials up to 10mm thick provided the safety saddle is removed.

Dimension ‘C’ can be increased by up to 7mm because of the slotted hole.

Double location weldmesh panel clip. The slotted design of the panel clip enables adjustment in the location of the mesh panels. Supplied with M6 x 30mm long nut and bolt. This fitting can also be used to locate other materials up to 10mm thick provided the safety saddle is removed.

Dimension ‘C’ can be increased by up to 7mm because of the slotted hole.

A combination fitting designed for use in the construction of racking systems. The fitting enables the connection of a vertical upright at 90° to two horizontal rails. One being the tie rail, the other being the load rail. On pallet racking the upright normally has the load rail on the inside, whilst for shelved racking the upright normally has the load rail on the outside.

A 90° offset crossover fitting. The tube is unable to be jointed within this fitting. Ideal applications are for racking systems or offset guardrail. Where dimension ‘D’ indicates two figures, the first figure refers to tube ‘A’, the second refers to tube ‘B’.

Offset add on tee. Used for making additions to, upgrading or modifying an existing structure without having the need to dismantle part or all of that structure.