WARNING: DUE TO THE NATURE OF THESE GALVANISED CASTINGS THE MEASUREMENTS GIVEN HERE CANNOT BE PRECISE. WE THEREFORE DO NOT RECOMMEND THAT ANY BOLT HOLES ARE PRE-DRILLED PRIOR TO INSTALLATION.
A structural base plate for all aspects of vertical post support. This fitting when used as a base plate for guardrailing should always be positioned with the holes across the line of the guardrail to give maximum strength.
The holes in the base plate are large enough to enable the use of mechanical or chemical anchor fixings.

WARNING: DUE TO THE NATURE OF THESE GALVANISED CASTINGS THE MEASUREMENTS GIVEN HERE CANNOT BE PRECISE. WE THEREFORE DO NOT RECOMMEND THAT ANY BOLT HOLES ARE PRE-DRILLED PRIOR TO INSTALLATION.
A structural base plate for all aspects of vertical post support. This fitting when used as a base plate for guardrailing should always be positioned with the holes across the line of the guardrail to give maximum strength.
The holes in the base plate are large enough to enable the use of mechanical or chemical anchor fixings.

WARNING: DUE TO THE NATURE OF THESE GALVANISED CASTINGS THE MEASUREMENTS GIVEN HERE CANNOT BE PRECISE. WE THEREFORE DO NOT RECOMMEND THAT ANY BOLT HOLES ARE PRE-DRILLED PRIOR TO INSTALLATION.
THIS FITTING IS NOT RECOMMENDED FOR USE AS A BASE PLATE FOR GUARDRAILING

With four countersunk holes, this fitting is ideal as a flange to terminate handrail to a wall or other similar application. This fitting may be used on structures where it is only required as a positional fixing.

WARNING: DUE TO THE NATURE OF THESE GALVANISED CASTINGS THE MEASUREMENTS GIVEN HERE CANNOT BE PRECISE. WE THEREFORE DO NOT RECOMMEND THAT ANY BOLT HOLES ARE PRE-DRILLED PRIOR TO INSTALLATION.
THIS FITTING IS NOT RECOMMENDED FOR USE AS A BASE PLATE FOR GUARDRAILING

With four countersunk holes, this fitting is ideal as a flange to terminate handrail to a wall or other similar application. This fitting may be used on structures where it is only required as a positional fixing.

Freely adjustable cross between 30° and 45°. Typical use is as a cross connection on angled mid/lower rails on steeper sloped or stairs with the upright remaining vertical. The upright must remain continuous with the cross rails being cut.

Not recommended for use on the top of the vertical.

Freely adjustable cross between 30° and 45°. Typical use is as a cross connection on angled mid/lower rails on steeper sloped or stairs with the upright remaining vertical. The upright must remain continuous with the cross rails being cut.

Not recommended for use on the top of the vertical.

Freely adjustable tee between 30° and 60°. Typical use is a tee connection on angled top rails on steeper slopes or stairs with the upright remaining vertical. This fitting can also be used for bracing on structures. This fitting has no ability to join tubes.

Freely adjustable tee between 30° and 60°. Typical use is a tee connection on angled top rails on steeper slopes or stairs with the upright remaining vertical. This fitting can also be used for bracing on structures. This fitting has no ability to join tubes.

A 3 way enclosed 90° corner joint. Typical use is on straight and level guardrail at a 90° corner where an upright is in position. This Q clamp fitting can also be used to create enclosed corner joints in other square structures such as benches etc.

A 3 way enclosed 90° corner joint. Typical use is on straight and level guardrail at a 90° corner where an upright is in position. This Q clamp fitting can also be used to create enclosed corner joints in other square structures such as benches etc.