WARNING: DUE TO THE NATURE OF THESE GALVANISED CASTINGS THE MEASUREMENTS GIVEN HERE CANNOT BE PRECISE. WE THEREFORE DO NOT RECOMMEND THAT ANY BOLT HOLES ARE PRE-DRILLED PRIOR TO INSTALLATION.

Designed for palm fixing of guardrail and balustrades to walls, parapets, steps and ramps. The upright cannot drop through the socket.

An adjustable structural base fitting for the vertical. The design of this fitting will only allow it to be installed in the correct plane.

An adjustable structural base fitting for the vertical. The design of this fitting will only allow it to be installed in the correct plane.

An adjustable elbow. Used for the connection of the first vertical post at the start of the incline to the top rail. Only one barrel has the ability to take the adjustability, the other is fixed.

An adjustable elbow. Used for the connection of the first vertical post at the start of the incline to the top rail. Only one barrel has the ability to take the adjustability, the other is fixed.

A variable angle in line connector (110° -180°) Ideally suited for use between the vertical end post and sloping top rail on stair guard railing.

A variable angle in line connector (110° -180°) Ideally suited for use between the vertical end post and sloping top rail on stair guard railing.

An adjustable cross for connecting tubes between mid/lower rails and the vertical on ramps or shallow gradients. The vertical must remain continuous with the cross rails being cut.

An adjustable cross for connecting tubes between mid/lower rails and the vertical on ramps or shallow gradients. The vertical must remain continuous with the cross rails being cut.

An adjustable tee connection between two tubes. Used on ramps and shallow gradient guardrail between verticals and top rails. This fitting can be used to joint tubes in the long tee.